V 2.0
Setup Guide Revised: 04-12-00
Digital 328 v2, ADAT And BRC Setup Guide
Contents: 1
Connecting The System
2
2
Digital 328 Setup
4
3
BRC and ADAT Setup
7
4
Notes On Single ADAT Operation
9
BRC / ADAT Setup Guide
1
1
Connecting The
Audio Connections Connect audio connections as shown in the diagram below. Toslink Optical cables must be connected from the ADAT Out ports of both the ADATs to the ADAT In ports of the 328 and vice versa. The ADAT connections allow digital transfer of either direct outputs for input channels 1-16 to the ADATs, or the Digital 328’s 8 Group outputs.
328 ADAT 1 Out Î ADAT 1 In
328 ADAT 2 Out Î ADAT 2 In
ADAT 1 Out Î 328 ADAT 1 In
ADAT 2 Out Î 328 ADAT 2 In
ADAT Master
ADAT Slave
Toslink Optical cables
Digital 328
Synchronization Connections Besides the audio connections, a BNC Wordclock cable must be connected from the 328 Wordclock Out to the BRC 48kHz input to synchronize the transmission of the samples.
NOTE
It must be decided whether MIDI Time Code (MTC) or Longitudinal Timecode (LTC or SMPTE) is to be used to transmit the timecode from the BRC to the 328. If LTC is to be used, MIDI connections must still be made, in order to enable the transmission of MIDI Machine Control (MMC). MMC is responsible for the transmission of the Transport and Locate Controls between BRC and 328. In the following diagram only the SMPTE/LTC cable is optional.
Spirit Digital 328 v2
2
Optional BRC SMPTE Out Î 328 SMPTE In
328 Wordclock Out Î BRC 48kHz Input 328 MIDI Out Î BRC MIDI In BRC MIDI Out Î 328 MIDI In
BRC ADAT Sync Out Î Master ADAT Sync In
Introduction
Master ADAT Sync Out Î Slave ADAT Sync In
Digital 328
To summarize, the connections required are as follows: BNC Wordclock cable: Digital 328 Wordclock out Î BRC Wordclock In MIDI Cables (required even if MIDI Timecode is not to be used): 328 MIDI Out Î BRC MIDI In BRC MIDI Out Î 328 MIDI In SMPTE Cable (required only if SMPTE is to be used) BRC Timecode Out Î 328 Timecode In Alesis Sync Cables: BRC Sync Out Î ADAT Master Sync In ADAT Master Sync Out Î ADAT Slave Sync In Optical Cables: ADAT Master Optical Out Î 328 8 Track A Optical In 328 8 Track A Optical Out Î ADAT Master Optical In ADAT Slave Optical Out Î 328 8 Track B Optical In 328 8 Track B Optical Out Î ADAT Slave Optical In
BRC / ADAT Setup Guide
3
2
Digital 328 Setup
Wordclock In a configuration using the BRC, the 328 must be made to be the Wordclock Master device. Enter the 328 Menu pages by pressing the