PLT 83368 75W LED Wall Pack Installation Instructions


[PDF]PLT 83368 75W LED Wall Pack Installation Instructions - Rackcdn.comhttps://a89b8e4143ca50438f09-7c1706ba3fabeeda794725d88e4f5e57.ssl.cf2.rackcd...

2 downloads 128 Views 84KB Size

LED SLIM CUTOFF WALL PACKS

INSTALL INSTRUCTIONS

PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION. Please read the instructions before you install and use the luminaire. • To prevent personal injury or product damage only licensed electricians should install. • To avoid electric shock or component damage disconnect power before attempting installation or servicing. • This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards. • Disconnect product and allow cooling prior to servicing. • Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction. • To prevent product malfunction and/or electrical shock this product must be properly grounded. • Wall mount only. • Not suitable for mounting within 4 ft (1.2 m) of the ground. • Suitable for wet locations. INSTALLATION WARNING: Make certain power is OFF before installing or maintaining fixture. MOUNTING 1. Loosen the screw on the side and open the fixture, attach to the wall using the installation holes. (Fig 1) 2. Close the fixture and lock the screw. WIRING 1. Complete the wiring to the power source and ground. (Fig 2) Universal voltage driver permits operation at 100V to 277VAC, 50 or 60Hz except fixtures factory ordered with a 120V photocell. 1. Connect the black fixture line to the (L) Live line supply wire. 2. Connect the white fixture line to the (N) Neutral line supply wire. 3. Connect the green fixture line to the (G) Ground line supply ground. CLEANING AND MAINTENANCE CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is powered on. 1. Clean lens and fixture with non-abrasive glass cleaning solution. 2. Do not touch or open fixture to clean the LED. TROUBLESHOOTING 1. Check that the line voltage at fixture is correct. Refer to wiring directions. 2. Make sure fixture is grounded properly.

0.87” 2.6” 3.38”

Fig 1

Wire Connection Live

Black

Neutral

White

Ground

Green

Without Photocell

Live

Black

Neutral

White

Red

Ground

Black White Green

With Photocell Fig 2