PTP Turbo Blanket Installation Instructions - NetSuite


[PDF]PTP Turbo Blanket Installation Instructions - NetSuitehttps://61bfba21cfb27d3414b0-33d79809264fd8f465f395acab527149.ssl.cf1.rackcd...

1 downloads 133 Views 614KB Size

 

PTP Turbo Blanket Installation Instructions  Congratulations on the purchase of your new PTP Turbo Blanket.  Please review the following  instructions to ensure proper installation and longevity of your Turbo Blanket. 

  Before installing your Turbo Blanket, please ensure that the engine and exhaust have had time  to cool.   Make sure the turbo does not have an exhaust leak or any oil leaks.  The PTP Turbo  Blanket is non‐flammable, but if oil saturates the material, it can quickly deteriorate the Turbo  Blanket.  Please also ensure that the exterior surface of the Turbo Blanket is not in direct contact with a  high  temperature  source,  such  as  an  exhaust  manifold  that  has  not  been  wrapped  or  heat  protected.  Turbo Blankets are designed to hold very high temperatures on the inside, but the  outer material is less resilient to high temperatures.   The  use  of  safety  glasses  and  gloves  is  recommended  during  installation.    The  fiberglass  material can irritate the skin.  A pair of wire snips will also be needed to cut the included wire  used for securing the blanket.  

PTP Turbo Blankets | www.PTPTurboBlankets.com | 512‐490‐6494 | M‐F 10A to 5PM CST 

 

  Locate the included fastening wire, unwind it, and cut it in half or to whatever length you feel is  suitable for your installation.    

  On one end of the cut wire, make a loop similar to above.    PTP Turbo Blankets | www.PTPTurboBlankets.com | 512‐490‐6494 | M‐F 10A to 5PM CST 

 

  Attach the loop to one of the side rivets of the Turbo Blanket as shown above.   

  Take the opposite end of the wire and loop it around the opposite rivet, as shown above, and  pull it until the blanket is held securely in place.    PTP Turbo Blankets | www.PTPTurboBlankets.com | 512‐490‐6494 | M‐F 10A to 5PM CST 

 

  Loop the wire around the first rivet while keeping the wire tight to avoiding slack.    

  Make a final loop around the second rivet, and begin to wrap the wire around the rivet a couple  of times.    PTP Turbo Blankets | www.PTPTurboBlankets.com | 512‐490‐6494 | M‐F 10A to 5PM CST 

 

  Cut and remove any excess wire and tuck the wire end under the rivet.     Follow the same steps for the other side of the Turbo Blanket if needed.  The blanket should fit  tight and snug.   Be sure to keep the Turbo Blanket clean of any oil, fuel, or grease.  Avoid using  harsh  chemicals  when  cleaning  the  Turbo  Blanket.  The  Turbo  Blanket  has  a  break‐in  period  which leaves an unusual odor.  This smell will disappear after a couple of days.   If  you  have  questions  or  require  any  additional  support,  please  call  us  at  the  number  listed  below.    Thank you!  PTP Turbo Blanket Staff 

       

 

PTP Turbo Blankets | www.PTPTurboBlankets.com | 512‐490‐6494 | M‐F 10A to 5PM CST