ECS MKV Jetta, GTI, EOS, Rabbit, R32 Pedal Cover

---

Installation Procedures

ECS MKV Jetta, GTI, EOS, Rabbit, R32 Pedal Cover Installation Instructions

This tutorial is provided as a courtesy by ECS Tuning. Proper service and repair procedures are vital to the safe, reliable operation of all motor vehicles as well as the personal safety of those performing the repairs. Standard safety procedures and precautions (including use of safety goggles and proper tools and equipment) should be followed at all times to eliminate the possibility of personal injury or improper service which could damage the vehicle or compromise its safety. Although this material has been prepared with the intent to provide reliable information, no warranty (express or implied) is made as to its accuracy or completeness. Neither is any liability assumed for loss or damage resulting from reliance on this material. SPECIFICALLY, NO WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHER WARRANTY IS MADE OR TO BE IMPLIED WITH RESPECT TO THIS MATERIAL. In no event will ECS Tuning, Incorporated or its affiliates be liable for any damages, direct or indirect, consequential or compensatory, arising out of the use of this material.

ECS MKV Jetta, GTI, EOS, Rabbit, R32 Pedal Cover Installation Instructions ECS MKV Jetta, GTI, EOS, Rabbit, R32 Pedal Cover Installation Safety first! Before you undertake this installation, it is important that you read the following instructions! Listed below are the necessary tools and skills required to complete the job. If the installation of this product seems overwhelming, please contact a qualified installer in your area. Tools Required: Drill Centering punch 1/16” drill bit 1/8” drill bit 3mm allen Phillips screwdriver Begin this installation by removing the existing pedal covers from both the clutch pedal and brake pedal. This will allow the new pedal covers to be installed.

ECS Tuning 1000 Seville Road, Wadsworth, OH 44281 Phone: 1.800.924.5172 www.ecstuning.com ECS Tuning 3095 Cleveland-Massillon Rd. Norton, Ohio 44203

ECS MKV Jetta, GTI, EOS, Rabbit, R32

Place the new dead pedal cover over the existing one, once you are satisfied Pedal Cover with the location drill two pilot holes into the plastic. Using the supplied Phillips Installation screws attach the new dead pedalInstructions cover.

Using the same method as before attach the accelerator pedal cover and clutch pedal cover using a 1/8” drill bit for the pilot hole. Use the supplied allen bolts and nuts to attach them in place. Since the brake pedal is metal not plastic is necessary to use the supplied center punch to mark the location of the pedal cover to ensure the drill bit does not move out of place when drilling. Then attach them with the allen bolts.

ECS Tuning 1000 Seville Road, Wadsworth, OH 44281 Phone: 1.800.924.5172 www.ecstuning.com ECS Tuning 3095 Cleveland-Massillon Rd. Norton, Ohio 44203 Phone 1-800-924-5172 Fax 330-825-4846 Web www.ecstuning.com

ECS MKV Jetta, GTI, EOS, Rabbit, R32 Pedal Cover Installation Instructions Finally, double check that you have tightened all of the pedal covers in place. This will ensure your pedal covers are securely mounted and will not become a driving hazard.

ECS Tuning 1000 Seville Road, Wadsworth, OH 44281 Phone: 1.800.924.5172 www.ecstuning.com