Instructions for Routine Maintenance for Your Fastlane


[PDF]Instructions for Routine Maintenance for Your Fastlane...

98 downloads 239 Views 32KB Size

Instructions for Routine Maintenance for Your Fastlane 1. How do I program my new remote control for my Fastlane unit? If you have received a new, replacement remote control for your Fastlane, you will need to program it so that your Fastlane receiver (the electrical control box) can understand the remote’s signal. The remote controls you received with the purchase of your Fastlane have already been programmed. To program a new remote: 1) Remove the lid of your Fastlane receiver. 2) Press and hold the “LEARN” button near the top of the box on the circuit board until the LED light is a solid and steady red. This will take about 2-3 seconds. Release the “LEARN” button. 3) Press and hold any of the buttons on the remote. The remote is programmed successfully once the LED light starts blinking rapidly. To clear the receiver’s memory, simply press and hold the “LEARN” button until the red light goes out. This may take up to thirty seconds. Clearing the receiver memory may be necessary if the receiver is not responding to the remote control and reprogramming the remote was unsuccessful. After clearing the memory, it will be necessary to program the remote again.