0 downloads
219 Views
1MB Size
Interior Entry Steps
Supplemental Guide Page 1 of 4
Parts List Interior Entry Step Hardware Kit (31) 3/4” Stainless Steel Machine Screw (21) 1/2” Stainless Steel Flathead Machine Screw (4) 1” Stainless Steel Machine Screw (4) Stainless Steel Fender Washer (6) Mounting Brackets (2) Self Drilling Screws Tool Required (supplied by others) Cordless Drill #2 Phillips Head Bit
Description The Interior Entry Steps are designed for fully in-ground pool installations. The stair provides "walkin" capability for those with special needs. The steps are made of the same material as the interior bench with slip resistant treads. The steps mount with stainless steel screws to the pool walls and accommodate any coping height or material.
Additional Considerations The Interior Entry Steps are side specific, therefore their position needs to be decided upon during the planning stages of your project. The interior entry steps are designed to rest on the rear base. A rear bench seat is recommended to be used in conjunction with the Interior Entry Steps, if a 48” or 54” pool has been selected.
Endless Pools Inc.
2.23.2010
Interior Entry Steps
Supplemental Guide Page 2 of 4
Installation Instructions Begin by attaching the mounting brackets (total of six) to the inside vertical face of the step. Use the provided flathead machine screws to attach. The mounting brackets should be seated against the textured face.
Mounting Brackets
Next, attach the two sides and back to the step base. Start with attaching the rear to the base. Align the holes in the back with holes in the tab of the base. Use the provided 1/2” countersink machine screws to attach. Then attach the left and right sides to the base. The mounting brackets should be facing the center of the step. Use the provided 3/4” machine screws to attach. Rear
Side facing pool wall
Base
Endless Pools Inc.
Side facing pool interior
2.23.2010
Interior Entry Steps
Supplemental Guide Page 3 of 4
Install the top tread first (The top step has a mitered back corner). There will be one screw in the horizontal face of the step, one screw in the vertical face of the step. Then install the four screws into the side of the top step through the outside vertical face of the step.
Once the top tread is in secured, place the entire step assembly into its intended position inside the pool. You will notice that the oversize holes in the base of the step will be placed over screws in the bench in the pool. Remove the screws in the bench and replace them with the 1” screws provided with step. Make sure to use the fender washer on the screws. Now that the step assembly is attached to the bench, secure the remaining two treads. Place the middle tread into place and secure with the three screws across the back of the horizontal face, one on the vertical face, and the four screws across the outside vertical face. Use the provided 3/4” machine screws to attach.
Endless Pools Inc.
2.23.2010
Interior Entry Steps
Supplemental Guide Page 4 of 4
Install the lowest tread and secure with three screws across rear of the horizontal face, four across the vertical face of the tread, and four across outside vertical face of the step. Finally, attach the steps directly to the pool wall. Insert the 2 self drill screws into the pre-drilled holes in the top of the rear face of the step and drill through the liner into the pool wall.
Endless Pools Inc.
2.23.2010
