[PDF]planter coffee table - Rackcdn.comhttps://cc831cbd7a5a3a616f82-5093119187eb17284bcf20613cda98f7.ssl.cf1.rackcd...
1 downloads
112 Views
572KB Size
PLANS BY ROGUE ENGINEER
PLANTER COFFEE TABLE
TOTA L D I M E N S I O N S : 4 8 " X 2 4 " X 1 6 " D I F F I C U LT Y L E V E L : B E G I N N E R
TOOLS REQUIRED
Drill / Driver Circular Saw Jig Saw
OPTIONAL Brad Nailer
ADDITIONAL REQUIRED ITEMS Tape Measure Pencil Iron Nail and String Safety Glasses Hearing Protection 7/64” Drill Bit (optional, if not utilizing Brad Nailer)
PURCHASE LIST: (1) 3/4” x 4’ x 8’ Hardwood Plywood (4) 7.5 in. Wood Round Taper Table Leg (4) Silver Dual Top Plate Iron-On Edge Banding 1-1/4” Wood Screws 3/4” Wood Screws 1-1/4” Brad Nails Wood Glue Primer, Paint and/or Stain Sand Paper (optional)
PLANS BY ROGUE ENGINEER
PAG E : 2
LUMBER CUT LIST:
TOP
LH SIDE
RH SIDE
CENTER
¾" X 4’ X 8’ HARDWOOD PLYWOOD
48"
7"
7"
7"
BOTTOM
SCRAP
CENTER BLADE ON 24"
SCRAP
48"
HELPFUL HINT To maintain grain lines and direction from top to sides, mark top side of the LH Side, Top and RH Side.
PLANS BY ROGUE ENGINEER
PAG E : 3
ASSEMBLY:
1
EDGE BAND & CUT HOLE Iron on edge banding, all sides of top and bottom and short sides of smaller boards.
12" 12"
TOP r=7 5/8"
BOTTOM
Place a nail or screw at center of circle. Then, string and pencil draw a 15-1/4” diameter circle (7-5/8” radius). Then, drill a large hole within that circle and cut off with a jig saw.
PLANS BY ROGUE ENGINEER
PAG E : 4
2
ASSEMBLE BOX Mark a line with a pencil center of center divider to assure nails are placed properly.
TOP
24" RH SIDE
CENTER
LH SIDE
235/8"
BOTTOM
Assemble box using wood glue and 1-1/4” screws (pre-drill holes using 7/64” drill bit) or use brad nails (not all shown).
PLANS BY ROGUE ENGINEER
PAG E : 5
3
FINISHING Sand out any rough spots or edges before painting/staining Finish box and legs as desired with primer & paint, stain, or a combination of the two!
PLANS BY ROGUE ENGINEER
PAG E : 6
4
INSTALL TOP PLATE & LEGS Locate dual top plate, 45 degrees and corners 3/4” from edges and install using 3/4” wood screws.
BOTTOM
Install 7-1/2” tapered legs on top plate as desired (straight or angled).
PLANS BY ROGUE ENGINEER
PAG E : 7