Pneumatic Light Switch Technical Bulletin No. 7APage


[PDF]Pneumatic Light Switch Technical Bulletin No. 7APage...

3 downloads 160 Views 43KB Size

Pneumatic Light Switch

Technical Bulletin No.

7A

Page 1 of 2

7.1 Parts List a. Lights Kit (1) Pneumatic Light Switch (TF-1TD) (1) Air Button (1) 50’ Length of 1/4” Air Tube

(1) 1 to 3 Outlet Cube Tap (1) Outlet Isolator

7.2 Description The Allied Innovations, LLC Pneumatic Light Switch (TF-1TD) is a solid state on/off air switch with a built in 60-minute “on” time delay feature. The unit plugs directly into any standard household wall receptacle. When used to turn your pool lights option on/off the receptacle should be GFI protected. Any 120 volt, light can be plugged directly into the TF-1TD. Install the air button at the front of the pool adjacent to the swim current switch. Should an alternate location be desired, contact our Customer Service Department at 800-910-2714 for recommendations. Connect the air tubing from the air button to the TF-1TD. Pressing the air button initiates a 60minute “on” time delay, after which the control automatically turns off. The air button can override the time delay and shut the light off at any time. Note: Ground connections are not shown and vary with installations. Caution: Must be connected to a designated ground-fault circuit interrupter (G.F.C.I.) line. TF-1TD

Endless Pools Inc.

8/12/04

Pneumatic Light Switch

Technical Bulletin No.

7A

Page 2 of 2

Typical Installation

WARRANTY Allied Innovations, LLC warrants its products to be free from defects in workmanship and material under normal use and conditions for a period of one year from the date of original manufacture. Should repair be required by reason of any defect or malfunction during the warranty period, Allied Innovations, LLC will repair, or at their discretion, replace this product without charge, subject to verification of the defect or malfunction, upon delivery of the product to the attention of: Technical Service Department Allied Innovations, LLC 7215 Bermuda Rd Las Vegas, NV 89119-4304

Allied Innovations, LLC shall not be liable for any inconvenience, loss of time, or incidental expenses incurred. Allied Innovations, LLC shall not be liable for any labor charges associated with the removal or reinstallation of any so-claimed defective products. This is the only warranty expressed or implied by Allied Innovations, LLC. Warranties implied under state law, including any implied warranty of merchantability or fitness for a particular purpose, shall be limited to one ear from the date of manufacture. Allied Innovations, LLC disclaims any liability for any incidental or consequential damages.

If repair is required after the expiration date of the warranty period, Allied Innovations, LLC will repair this product and bill for any necessary replacement parts, shipping and handling.

Ship as follows:

This warranty is void if: 1) the unit is not installed per the instructions; 2) is hooked up to improper voltage; 3) is subjected to chemical corrosion; 4) is mechanically or electronically altered in any way; 5) is subjected to water immersion; 6) contacts show evidence of short circuiting, or the unit has been visibly damaged by accident or misuse or which has been damaged by lightning, freezing or other cause; or upon which the serial number or manufacture date has been altered, affected or removed. There is a charge for replacement parts if the defective unit is returned for any of the reasons listed above.

2. Include name, return address, and daytime phone number along with a short description of problem with control.

Endless Pools Inc.

1. Pack the unit in a well padded, heavy corrugated box.

3. Mail the unit, prepaid, to the above address. Some states do not allow the exclusion or limitation of incidental or consequential damages, therefore the above limitations may not apply to you.

8/12/04