Tool Tray User Guide

---

Tool Tray Kit User Guide Layout & Assembly 1. To make the body, lay out all the lines – there is no cutting on this piece. Bend the 1/4" hems (1) at each side back on themselves. Bend the other lines (2) up 90° as shown below. 2. Lay out the ends by finding the center line (CL) and marking and cutting the outline. Lines 5 and 6 fold back on themselves. Bend Line 3 and then Line 4 up 90°. 3. Lay out the handle. Make the 1/2" cuts (7). Next, hem handles on the lines (8). Bend these up 90° along the line (9) and bend out the tabs (10). (continued on back)

Tool Tray Kit User Guide 15096 V0311

4. Assemble the tray bottom and ends with the end flaps toward the outside of the sides. Drill and set two rivets into each of the four flaps to fasten them to the sides. 5. Holding the handle in place, drill and set two rivets in each end to fasten the handle to the ends. 6. File off all sharp corners and edges.

Rivets Rivets

Care & Maintenance

Rivets

• The cold rolled steel comes lightly oiled to prevent rusting while in storage. This oil can be removed with laquer thinner. • Common deposits of dirt and grease are quickly removed with a detergent and water. Periodic cleaning will maintain the bright surface of your tool tray. • Salty solutions should not be allowed to evaporate and dry on the steel as they may cause corrosion. • It is a good idea to paint the tool tray. Be sure to use a metal primer as an undercoat. Spray enamels work well.

P.O. Box 1708 • Pittsburg, KS 66762 www.pitsco.com Toll-Free Orders 800-835-0686

Tool Tray Kit User Guide 15096 V0311